Separation Techniques Lab
Background:
An atom is the smallest unit of matter. An element is a pure chemical substance consisting of one type of atom. The difference between compounds and mixtures are that compounds are 2 or more types of elements that have been chemically bonded to form a new substance while a mixture is 2 or more atoms of different types that are mixed together without being chemically 1. Two different classifications of mixtures are homogenous and heterogeneous mixtures, the difference is that homogeneous mixtures are mixtures that become one and heterogeneous mixtures are mixtures that do not become one.
Materials:
• Heterogeneous mixture containing sand, iron fillings, and table salt. • Filter paper • Magnet • Funnel • Water • * Hot plate – heat safety, plate can burn you. • * Evaporating dish – heat safety, dish will be hot after being placed on hot plate. • * Stirring rods – glass safety, it can shatter if dropped. • * 250 mL beaker- glass safety, it can shatter if dropped.
* For these procedures do not forget to include all your safety guidelines.
Procedures:
• Put all of the substances in the beaker and mix them up. • Pour mixture on a piece of paper and pass magnet over to separate the iron fillings. Record mass and write on chart. • Put back sand and table salt back in the beaker. • Add less than 100 mL of water in the beaker. • Stir using stirring rods. • Weigh filter paper, and write your name on the side with a pencil. • Filter the water with filter paper, with a funnel and a larger beaker on the bottom so the water can drip out. • Take filter paper out of the funnel and place it in the fume hood so excess water can evaporate. • Place beaker in evaporating dish.
Data/Results:
Substance
Mass
Starting Mass (g)
Mass Retrieved (g)
Percent Error (%)
Iron
5.0 g
5.01 g
4.88 g
-2.6%
Table Salt (NaCl)
10.0 g
10.01 g
9.8 g
-2.1%
Sand
15.0 g
15.04 g
14.89 g
-1.0%
Calculations:
Iron: 4.88-5.01/5.01*100= -2.6%
Table Salt (NaCl): 9.8-10.01/10.01*100= -2.1%
Sand: 14.98-15.05/15.04*100= -1.0%
Conclusion:
The properties f matter my group used to separate the heterogeneous mixture was magnetism, soluble, and insoluble substances. We had a homogeneous mixture once the iron and the sand had been removed, and the remaining substances were just salt and water. This was separated using a hot plate to
Part A: Sodium benzoate is used to preserve certain foods against bacteria, yeasts and molds and is used to prolong their shelf life. This compound, when ingested has the potential to mix with stomach acid and undergo a chemical reaction. In a lab, sodium benzoate can be combined with hydrochloric acid (HCl) to simulate the stomach environment. The purpose of this experiment is to determine when these two substances are combined, whether a new substance will be formed. It was predicted that…
titrations in part II and III. Once we determine that, we use it with the sets of titrations with NaOH. Both Marisa and I will equally do work for both parts I, II, and III. Part I - Acid-Base Titrations with Chemical Indicators We obtained a 24 chem well-plate, 40 mL of HCl, and 100 mL of NaOH. We cleaned out a buret with the base, NaOH. We then obtained three different indicators: Boomcreiol green, Methyl orange, and 1% Phenolphthalein. Using the well-plate we sorted the indicators into 3…
Keira Harris February 16, 2015 Step 1. Converting copper metal to copper nitrate. 1. Cut and weigh of copper wire until approximately 0.5g. 2. Record mass. 3. Place in a clean, dry 250 mL Erlenmeyer flask. 4. Measure 4-5 mL of concentrated nitric acid in a graduated cylinder. 5. In a fume hood, add the acid to the copper until it dissolves. 6. Swirl contents to dissolve copper. 7. If after 5 minutes it hasn't dissolved, gently warm on a hot plate or add 1-2 mL of nitric acid. 8. Swirl until…
I. Determining the Unknown Acid Sample Size Identification code of unknown weak acid #5 Concentration of NaOH solution, M .0609M Mass of weighing paper plus unknown acid,g .86 g Mass of weighing paper,g .8 g Final buret reading, mL 19.2 mL Initial buret reading, mL 13.5 mL III. Titrating the Unknown Acid Determination. 1 Determination 2 Mass of weighing paper plus unknown acid, g .922g .90g Mass of weighing paper, g .87…
Chem-101 Name_________________________ Date__________________________ THE MOLAR VOLUME OF HYDROGEN: THE REACTION OF MAGNESIUM WITH HYDROCHLORIC ACID PURPOSE: • The molar volume of hydrogen gas will be determined by experimentally measuring the volume of hydrogen evolved during the reaction of magnesium with hydrochloric acid. • The universal gas constant will be measured and class data will be combined for statistical data analysis. Mg(s) + 2HCl(aq) → MgCl2(aq) + H2(g) Laws and concepts…
II. Intro/Background Light is a continuous spectrum of frequencies and wavelengths. Depending on the size of the wavelength, its frequency will either be higher or lower. All light waves travel at the same speed. In this lab, you will be conducting an experiment to determine the effects that different color ultraviolet lights have on a glow star. III. Hypothesis We predict that the glow star will produce the color of the light that is shined on it. We predict this will occur because the waves…
Marriah Miranda CHEM 1411 February 4, 2015 Precision and Accuracy of Scientific Glassware Pre-Lab Report The objective of this experiment is to learn which scientific glassware should be used in various circumstances, how to measure volume and mass and how to record laboratory data and observations. Become familiar with significant figures, errors, precision and accuracy associated with the various tools and techniques. To Contain Glassware you will need two Erlenemeyer Flasks, one 125 mL to measure…
Lab report Introduction- An ester is “any class of often fragrant organic compounds that can be represented by the formula RCOOR′ and that are usually formed by the reaction between an acid and an alcohol with elimination of water.” We set out to create these esters on our own by combining acids like acetic acid, butyric acid, and benzoic acid with certain alcohols like ethanol, methanol, or pentanol. Each had a unique smell, which we would try to determine by smelling each. Objective- To…
Adam Meyer 18 Feb 2015 Experiment 1A The production and testing of Ca(OH)₂ with other substances Refer to pgs 1-8 for more laboratory information. . . Our Objectives . Observe the reaction between limewater and carbon dioxide; and to test the gaseous products of two chemical reactions for the presence of carbon dioxide. ( refer to the textbook pg 1 for further instruction.) . . Materials and Procedures . ( refer to the text book pg 1-2 for a full list of materials.) . . Observations and Data…
involves strong electrolytes are completely dissociated into ions in diluted solutions. In this lab both the base and acid were strong electrolytes. The heat of neutralization for all reactions involving strong electrolytes will be constant and the same amount of heat will be formed (Petrucci et al., 2011). Procedure The experimental procedure used for this experiment was outlined in the CHEM 120L lab manual, experiment #4. All steps were followed without deviation Observations Part A: Heat of dissolution…