10 Gigabit Ethernet
From its inception, 10G Ethernet was intended to retain backward compatibility and full interoperability with 10/100/1000M bit/sec Ethernet while adding a tenfold increase in performance.
In 10/100 and Gigabit Ethernet, the MAC layer works in a linear manner - data moves serially in and out of the MAC layer with all the starting and ending control messages (including clocking and synchronization) embedded inside the datastream. With 10G Ethernet, it is much more complex.
To attain a 10G bit/sec bandwidth rate, the IEEE altered the way that MAC layer interprets signaling. Rather than producing a serial stream, the 10G Ethernet layer operates in parallel to interpret data. The transmit and receive paths each comprise four data lanes, and the datastream broken down into bytes is handled in round-robin fashion across the four lanes, numbered 0 to 3. On the transmit path, for example, the first byte aligns to Lane 0, the second byte to Lane 1, the third byte to Lane 2, the fourth byte to Lane 3, the fifth byte back to Lane 0, and so on.
Ethernet frames have clearly defined beginning and ending boundaries, or delimiters. These are marked by special characters and a 12-byte interpacket gap (IPG) that dictates the minimum amount of space or idle time between packets.
Because of the parallel nature of the 10G Ethernet MAC layer, it is impossible to predict the lane in which the ending byte of the previous datastream will fall. This makes finding the starting bit - a requirement for maintaining timing and synchronization - more difficult. The 802.3ae standard mandated an elegant solution: the "start control character," or very first byte of a new data frame, must always align on Lane 0. However, this solution complicates the way the MAC handles the IPG, directly affecting performance. Nevertheless, the IEEE provided three options for the vendors to address this issue: 1) pad (increase), 2) shrink, or 3) average the "minimum" IPG.
Padding increases the IPG
If the ending character of the previous packet falls into 12th slot in the 12-byte IPG, the MAC layer does nothing and maintains the 12-byte minimum IPG, and the starting character of the next packet automatically aligns in Position A of Lane 0. If, however, the ending character of the previous packet falls into other positions, the MAC layer must add bytes respectively into the IPG to ensure that the starting character of the